IOtech announced Calibration Module for their 600 Series, an intuitive software product that will give customers the ability to perform factory grade calibration and verification on IOtech’s 600 Series of Dynamic Signal Analyzers. The Calibration Module for the 600 Series provides intuitive automated and manual mode operation for calibration and verification of IOtech Dynamic Signal Analyzer models 640e, 640u, 650e, and 650u. Upon completion of calibration, this package creates a report that documents specific device information, each calibration and verification step executed, and pre- and post-calibration data. It also provides the ability to perform verification of the ZonicBook/618E and the WaveBook/516E. The Calibration Module for the 600 Series is a software add-in to National Instruments Calibration Executive Software, and is intended for use in a metrology laboratory.

The Calibration Module for the 600 Series is priced at $999. The NI Calibration Executive Software is priced at $2,499.